Flexus Stik Aspire Pod Kit

MANUAL :

Before starting your pod, press the button on the bottom of the pod three times to set the desired volt output. Depending on the color of the LED surrounding the base of the battery, the volt power will be different:

Green LED (High) power set between 3.8 and 4.2V

Blue LED (Mid) power regulated between 3.5 and 3.8V

Red LED (Low) power set to 3.5V

You can then directly place your lips on the drip tip and suck in automatic mode, but you can also press the button below at the same time as you take a puff, the choice is yours! By rotating the cartridge you can adjust the air entering your pod.

To turn it on or off , quickly press the Fire button 5 times.

To charge your pod's built-in battery , plug the USB cable into the USB-C port located above the LED light. Charging is very fast and the LED will light up green when it is between 60% and 100% of its battery life and it is recommended to use the USB-C cable provided to benefit from it.

Remaining charge level: 

Green LED pod recharged between 60% and 100%

Blue LED pod recharged between 30% and 60%

Red LED pod recharged between 0% and 30%

Other LED indications:

The LED flashes 10 times in red and blue: puff time greater than 10 seconds. The pod moves to safety.

The LED flashes red and blue three times: short circuit.

The LED flashes red 15 times: low voltage.

The LED remains yellow for 3 seconds: overheating.

To fill the cartridge, pull on the cartridge located at the top of the pod to unclip it. Turn the cartridge over and remove the silicone cap then pour an e-liquid into the opening (use e-liquids with a maximum of 50% vegetable glycerin for perfect vaporization). Close the silicone cap and clip the cartridge back into your Flexus Stik pod. If the cartridge is correctly inserted, the LED will flash blue once.

To replace the coil, remove the removable pod cartridge and unclip the used coil. Then clip the new resistance into the cartridge. Re-clip the cartridge correctly into your Flexus Stik pod.

Attention ! When using a new coil, whatever the model of your equipment, you must first prime it, that is to say ensure that the coil is soaked in e-liquid and avoid thus “burning” the dry cotton. The easiest way is to wait at least 10 minutes after filling before using the electronic cigarette. Other priming techniques are faster and safer.

PRECAUTIONS FOR USE: 

Keep the device out of the reach of children and pets.

Only use the USB cable provided by the manufacturer during a firmware update or reload.

Fill the cartridge before vaping even if it is not completely empty to avoid a dry hit.

Avoid using the Aspire Pod Flexus Stik Kit in humid, dusty environments, or with extreme temperatures.

Do not use nicotine e-liquid for people under 18 years of age, pregnant or breastfeeding women, people with cardiovascular disease or dysfunction, long-term respiratory problems (bronchitis, asthma), hypertension or diabetes, people with an overactive thyroid gland or suffering from pheochromocytoma, and people taking the medications Theophylline, Ropinirole or Clozapone.

For possible side effects, contact the manufacturer.

TECHNICAL SHEET